#Cateye mighty 8 install

When you want to input the reading of the currently used odometer, keep pressing the MODE button for two seconds and input the reading.

Mount sensor and adjust the gap between the magnet and the sensor. Select the measurement unit, kilometer or mile, by pushing the MODE button. SET Buttonĥ Magnet 6 Bracket Rubber Pad 7 Nylon Ties (5)ĥ on a spoke of the front wheel so that the surface of the magnet will face the sensor. * Do this procedure without fail for stable measurement when you use this system for the first time and every time the battery is replaced. The computer is combined with the following parts.ġ Bracket 2 Cord 3 Sensor 4 Sensor Rubber PadĪll Clear Push three buttons (MODE, START/ STOP and SET) at the same time. Installation of the Computer on Your Bike Please don’t throw away this manual, Keep the manual at a place easily accessible. NoteĬomputer Set-up (For 1st use or after replacing the battery)

Important Don’t use thinner, benzene or alcohol to wipe the surface of the computer.

Never attempt to disassemble the computer head.

Avoid unnecessary prolonged exposure to the sun.

#Cateye mighty 8 install

Please read these instructions carefully before attempting to install and use your CAT EYE MITY 8 computer so that you understand the functions of this product. Dispose of batteries according to local regulations.

Keep batteries out of reach of small children.

Periodically check to insure they are mounted securely and the screws are not loosen.

Be sure to securely mount the magnet, the sensor, and the bracket on your bicycle.Pay attention to the road or trail! Do not be distracted by the computer.CAT EYE MITY 8 CYCLOCOMPUTER CC-MT400 E: Owner’s Manual